DIY sewing shoulder dress | FREE sewing pattern ep 05

How to sew ➥ https://goo.gl/E96E9B
Step1: With right sides together (RST) align the dart leg markings and sew together. Start at the base of the dart and sew to the tip. Your last stitch should go right off the edge of the fabric. Instead of backstitching tie your thread tails in a double knot. Press the darts downward.
Step2: Join the side front pieces together to create princess seams. Pin and Sew. Repeat for other side and facing
Step3: Fold the strap pieces in half lengthways, aligning the long raw edges, right sides together, and pin. Sew the long edges together using a 6mm seam allowance, then turn out through one of the open ends and press.



Step4: Place the straps to between the front pieces and facing, 1.2cm from the edge. Pin and sew.
then align the opposite strap end along the top edge of the back bodice and repeat for the other side. and check that the strap length is correct, making adjustments if necessary. Pin and sew


Step5: With right sides together front and back of top. Pin and sew seam side from edge main fabric to edge of the facing. Repeat for other side


Step6: Fold dress hem 1/4" towards the wrong side two time and press. pin and sew a long straight stitch. 


Step7: Stitch a collected stitch along the top edge of the skirt. Gently pull the top edge until it is the same width as the lower edge of the top. Pin and sew


Step8: Mark each buttonhole 4cm apart, then make each one. 


#zoediy, #diysewing, #freepattern , #shoulderstrap, #dress
Chart size (inch)
Chart size ( cm )